Skip to main content

Cushion tutorial part 1 (piping)

 



Welcome back to my fourth tutorial, part 1.




In this tutorial I show you how I apply self-made piping to a square cushion. 

It addresses what size to cut your cover, how to apply the piping to avoid corner 'ears' and what I do when I come to join the ends of the piping so that you have a perfect join and therefore eliminate something which maybe a bit bulky and obvious.


I am hoping this may be useful to you....part two will follow on.


Much love, Gill x





Comments

  1. Great to see how you do your final join, it's so neat! I look forward to trying it out.
    I usually overlock my piping but do you think I shouldn't bother?
    Thanks Gill! x

    ReplyDelete
    Replies
    1. Hi Cathy, thanks for your comments... I don’t bother to overlock my piping as I feel its only the main cushion fabric that I really want to stabilise x

      Delete
  2. Thanks Gill, great tutorial, love the final join tip! Do you make your piping on the bias? Thanks, Claire x

    ReplyDelete
    Replies
    1. Thank you Claire. I cut my piping on a slight cross - but not the true bias (at 45 degrees) The only time I would but on the true bias is if it was a check and the pattern would look better. One note: don’t ever cut velvet at 45 degrees... it opens up the pile and it looks awful - just cut slightly on the cross as usual. Gx

      Delete
  3. Hi Gill, do you ever overlock your piping strip? Great video, by the way!

    ReplyDelete
    Replies
    1. Hi Helen, Thanks so much for your comments. I don't overlock the piping - unless it really is falling apart! Gx

      Delete
  4. Thanks Gill so quick and easy I am going to copy you!!

    ReplyDelete

Post a Comment

Popular posts from this blog

Quick tip on how to cut fabric straight

Following a few requests on how to cut fabric straight, I have done a very quick tutorial. As always if you have any questions, please don't hesitate to contact me in the comments box below. Much love,  Gx

Tutorial on making Roman blind pockets (buckram)

  In this video I will show you how I make my Roman blind pockets using buckram to reinforce them.  *Please note: There is a slight error (which I have not been able to edit) where I say that I have cut my lining to 135cm wide, this is a mistake, it is cut to 113cm wide the same as the finished width of the Roman blind. ________________________________ You can buy 2.5cm wide single fusible buckram on a roll, but if you don't have that and would like to give it a go, you can tear your normal buckram as shown in the video. The measurement of the lining that I am making is set out below.  Once you have watched the tutorial hopefully this will make sense. The first two pockets are made slightly shallower than the rest to accommodate the breakaway clips (or handbags) as I like to knot under the toggle to save the cord pulling through and being lost in the spool.   This is compliant with the current child safety methods. Once I have attached the lining to my blind, I then mark out my eye

Interlining tutorial

Well this is exciting! my first video tutorial...! This is how I join interlining using an overlocker, with a stitch known as a  flat-lock  stitch.  It is super quick and easy and doesn't make one side grow more than the other so there is no lumpy interlining to deal with. One little note though, make sure if you are joining more than two widths that you join all the widths with the 'flat' side all on one side of the interlining so that when you come to use it you don't have one flat seam and one ridge seam on the same side! I really hope you enjoy these and that you can take something away from each one. Much love,  Gill x